MERCURY M800 FIBREGLASS FILLER with HARDENER Packing: 280gm or 1.25kg
Mercury M800 Fiberglass is a high quality reinforced filler designed to repair and bridge holes. Its strength and fast drying properties produce strong surface. It is suitable for most repair. Available in rough & fine fibre foam.
带有HARDENER的MERCURY M800玻璃纤维
-Mercury M800玻璃纤维是一种高质量的增强填料，旨在修复和搭桥孔。
它的强度和快速干燥性能可产生坚固的表面。适用于大多数维修。提供粗糙和细纤维泡沫
SKU: 99000802
Categories: KJ HARDWARE
Instruction for Use :
- Surfaces must be clean, dry and free of oil or grease. Any loose paint and rusted metals should be removed and the area sanded down to a sound surface.
*The correct hardener addition is 2% (by weight) M800 has a rapid gelation and cure time.
At normal temperatures, M800 has a working time of some 5 minutes and will cure in about 20 minutes.
The hardener can also be added in proportion i.e.
Quarter of the paste requires of the hardener.
Adding more hardener reduces the working time (gelation) and adding less hardener lengthens the working time.
Mix the hardener and filler together until an even colour result.
M800 has a high glassfibre content and is not designed as a surface finishing body filler.
For super line surfaces skim coat with few Mercury Polyester Putty.
带有HARDENER的MERCURY M800玻璃纤维
-Mercury M800玻璃纤维是一种高质量的增强填料，旨在修复和搭桥孔。
它的强度和快速干燥性能可产生坚固的表面。适用于大多数维修。提供粗糙和细纤维泡沫。
使用说明：
-表面必须清洁，干燥且无油或油脂。应清除所有松散的油漆和生锈的金属，并将该区域打磨到良好的表面。
*正确的固化剂添加量为2％（按重量计）M800具有快速的胶凝和固化时间。
在正常温度下，M800的工作时间约为5分钟，并且将在20分钟左右固化。
硬化剂也可以按比例加入，即硬化剂所需浆料的四分之一。
添加更多的固化剂会减少工作时间（胶凝），而添加更少的固化剂会延长工作时间。
将固化剂和填充剂混合在一起，直到获得均匀的颜色。
M800玻璃纤维含量高，不能用作表面光洁度的身体填充物。
对于超级线条表面，脱脂涂层要少加水银聚酯腻子。
